A. O. Smith CAHP line of commercial heat pump water heaters brings the right mix of energy efficiency and affordability to the commercial water heating market.
CAHP extends the MasterFit tradition of unmatched flexibility in heating capacity with a powerful Heat Pump module that guarantees continuous electrical and operating cost saving.
This balance in design ensures an ROI worth evaluating for any commercial establishment that uses hot water in operations.
Efficient Renewable Energy Technology
This water heater is a highly efficient, energy-saving and environment-friendly device. While running in energy-saving mode, users can save up to 70% on electricity costs when compared to a conventional electric water heater.
AES (Adaptive Energy Saving system) function
This water heater has a unique AES feature which adopts the heating cycles to the water utilization habit of the user. This enables the water heater to switch on automatically at the required time, saving energy by minimizing thermal losses.
Blue Diamond Glass Lined Tank
This water heater comes with a special glass-lined tank. This lining offers the protection against tank corrosion and increases the life of the water heater and it is achieved through a specialized fusion process.
The tanks are designed to pass 100,000 cycle fatigue test. This makes it one of the best tanks resistant to rust and scaling.
Outer Coil Heat Exchanger
Large surface area of the Heat exchanger moves heat from refrigerant to the water efficiently.
Double Wall Refrigerant Isolation
Refrigerant is isolated from water from both sides, providing extra safety and protection for the water heater.
Glass-lined Electric Heating Element
Dual 3kW backup heating element helps in quick heating.
Tank insulation minimizes standby heat loss so generated hot water stays longer and reducing energy requirements.
Wired Remote LCD Control
Digital user interface provides easya access to temperature, feature and mode settings.
Adjustable Mode Settings
This water heater can be set by the user to operate in different energy modes: Efficiency mode prioritizes use of heat pump module; High Demand mode combines heat pump and electric element for extra high recovery usage
High Temperature Limit Protection Switch
This water heater employs a high-temperature limit protection switch. In case any fault occurs and the water temperature exceeds the highest preset temperature, the switch rapidly cuts off the phase and neutral line simultaneously to guarantee safety.
A safety valve for the water heater is provided and set while leaving the factory and it is not adjustable by the user. The safety valve must be installed at the inlet pipe of the water heater.
This valve will relieve pressure automatically while the piping system exceeds the rated pressure. The discharge port of the safety valve and the condensate pipe should be connected to the floor drain through the three-pass discharge pipe.
Sacrificial Anode Rod
Anode rod protects the glass lining inside the tank to prolong the life of the water heater.
Waterproof Outdoor Design
Can be installed in an outdoor setting gives you more flexibility in installation location.
|Heat Pump Specifications|
|Heat Pump Input||1.25 kW|
|Heat Pump Heating Capacity||4.13 kW|
|Electrical||220V 60Hz 1ph / 380V 60Hz 1ph|
|Backup Element||6 kW|
|Max. Operating Current||41.6A / 15.8A|
|Unit Maximum Power||9.7 kW|
|Unit Maximum Heating Capacity||10.13 kW|
|Storage Capacity||80 gallons (300L)|
|Hot Water Delivery Rate (Efficiency)||89 lph|
|Hot Water Delivery Rate (High Demand)||218 lph|
|Maximum Water Temperature in Efficiency Mode||65 degrees Celsius|
|Temperature Range||35-82 degrees Celsius|
|Ambient Temperature for Heat Pump||5-48 degrees Celsius|
|Ambient Temperature for Unit||-15-50 degrees Celsius|
|Sound Level||57 dBA|
|Air Outlet Noise||60 dBA|
|Connections||3/4" NPT (Female Thread)|
|Overall Height||1670 mm|
|Tank Diameter||610 mm|
|Maximum Depth||901 mm|
|Door Width||503 mm|
|Net Weight||165 kg|
|Operation Weight||465 kg|